0%

Thank you for purchasing your CAN-AM charge tube from BMP! This product has been designed to work with our parts to help maximize Horsepower and maintain lower boost temperatures for more consistent performance. For best results, we recommend using the BMP Turbosmart diverter valve or the atmospheric BOV.   

 IMPORTANT - Please follow the instructions below. If you are unsure of how to perform the below tasks, please consult your service manual or bring the machine to a qualified technician.

  1. Remove the access panel located in between the seats.
  2. Located behind the panel is the Turbo itself. Loosen the clamp holding the stock charge to on the intake side of the Turbo.
  3. Follow that hose up to the intercooler and loosen that clamp on the intercooler itself.
  4. Remove stock charge tube from machine.
  5. This next step is optional. You can remove the 2 10mm bolt on each side of the intercooler and lift the intercooler itself and unplug the fan while doing so. This gives you a lot more room to work for installing the new Bikeman Charge tube and BOV.
  6. Put the NEW charge pipe on the intake side of the turbo and reuse the factory clamp.
  7. Pace BOV or Turbosmart Valve into the new charge tube and clamp it tight. If running the Turbosmart Valve, put on filter on exit side of the valve for protection against mud and water.
  8. You want to remove the factory plug in the intake for the vacuum to the new BOV 10mm bolt holding it down.
  9. Place the new fitting in the intake and bolt it back in with the factory bolt you removed.
  10. Take the 14inch hose that came in the kit and connect it to the fitting and BOV and clamp both sides with the provided clamps that came in the kit.
  11. If you did so place the Intercooler back in the machine and tighten the four 10mm bolts you removed to take the intercooler out. Don’t forget to reconnect the fan to the wire harness.
  12. Install the other side of the new charge tube on the intercooler and tighten it down with the factory clamp.\
  13. Replace the panel in between seats and you are ready to ride!

 

Tags: x3rr x3 utv install can-am